Diesel Injector Fuel Injector 095000-1020 Denso Injector

The low impedance injector will show you a range of 2 to 5 ohms, which you will need to repeat for all the samplers, and the resistance should be nearly similar between each injector. If you find a big difference in the resistance of any nozzle, that means you need to check the nozzle as well. To find the exact resistance of the fuel injector, you can search the vehicle's service guide.

Finally, we will test the fuel injector wiring to ensure that everything is properly connected. In this test, you need to keep the key in the second open position. This way, you can get battery power without turning on the engine. Now, you need the DVOM to measure the DC voltage in the same way as before.

If the meter does not have an automatic range at this time, set it to the lowest, pick up the negative terminal of the DVOM, ground it, remove the positive terminal of the meter, and connect it to the harness terminal. After doing this, one terminal should read 0 volts and the other should read 12 volts or approximately 12 volts. You need to test the wiring harnesses of all fuel injectors while keeping the ground wires in place. If each injector reads about 12 volts, all is well. However, if the degree is too low, there is a problem with the wiring.

conclusion

If you find problems with the car during these tests, you should take the car to a professional repair shop. By properly installing the fuel injector operation, you will save a lot of money that would otherwise be spent more on fuel.